Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985CHEVY VAN G20, 6.2 C, STANDARDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 16 (ENGINE CONTROLS - TESTS W/CODES - 5.0L)TROUBLE CODE CHARTSCODE 13, OPEN OXYGEN SENSOR CIRCUITDIAGNOSTIC AIDS
1985 Chevrolet Chevy Van G20, 6.2 C, Standard
Diagnostic Aids
1985 Chevrolet Chevy Van G20, 6.2 C, StandardSECTION Diagnostic Aids
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 1994 GMC Vandura, 1994 GMC Rally, 1994 GMC Pickup, 1994 Chevrolet Sportvan, and 1994 Chevrolet Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Verify a clean, tight connection for the sensor ground. An open circuit at sensor signal terminal or ground terminal will result in a Code 13.
CODE 13 TERMINAL & CIRCUIT WIRING IDENTIFICATION
| Application | PCM Terminal | Wire Color | ||
|---|---|---|---|---|
| "C" & "K" Series | ||||
| 5.0L A/T | ||||
| Oxygen Sensor Signal | A10 | Purple | ||
| Oxygen Sensor Ground | A12 | Tan | ||
| 5.0L M/T | ||||
| Oxygen Sensor Signal | D7 | Purple | ||
| Oxygen Sensor Ground | D6 | Tan | ||
| "G" Series | ||||
| 5.0L A/T | ||||
| Oxygen Sensor Signal | A10 | Purple | ||
| Oxygen Sensor Ground | A12 | Tan | ||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.