Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985CHEVY VAN G20, 6.2 C, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONMANUAL TRANSOVERHAUL - NEW PROCESS A833 4-SPEED ODCOMPONENT DISASSEMBLY & REASSEMBLYGEARSHIFT HOUSING & MECHANISMDISASSEMBLY
1985 Chevrolet Chevy Van G20, 6.2 C, Standard
Gearshift Housing & Mechanism: Disassembly
1985 Chevrolet Chevy Van G20, 6.2 C, StandardSECTION Disassembly
- If oil leakage is visible around lever shafts or if interlock levers are cracked, remove shift levers and shafts. Make sure shafts are free of burrs before removing to avoid damaging housing bores.
- Remove "O" ring retainers and "O" rings from housing. Remove "E" clip from interlock lever pivot pin. Remove interlock levers and spring from housing. Remove reverse detent spring and ball from bore of case.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.