Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985CHEVY VAN G10, 5.0 H, STANDARD, MY6REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMFUEL INJECTION SYSTEM - 6.2L DIESELTESTINGINJECTION NOZZLETEST PREPARATION
1985 Chevrolet Chevy Van G10, 5.0 H, Standard, MY6
Test Preparation
1985 Chevrolet Chevy Van G10, 5.0 H, Standard, MY6SECTION Test Preparation
- Remove injection nozzle from engine. Clean carbon from tip area of nozzle with soft brass wire brush. DO NOT use steel brush or motorized brush to clean nozzle tip. Damage to nozzle tip may result.
- Connect nozzle assembly to injection nozzle tester. Close tester shut off valve to pressure gauge. Fill tester with test fluid. Fill and flush nozzle assembly with test oil by operating tester lever briskly and repeatedly. This purges air from nozzle and coats all parts with test fluid.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.