Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1985CHEVY VAN G10, 4.3 N, AUTOMATIC, 475/M40REPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEM4.3L/5.0L/5.7L TESTS W/CODES
1985 Chevrolet Chevy Van G10, 4.3 N, Automatic, 475/M40
4.3L/5.0L/5.7L Tests W/Codes
1985 Chevrolet Chevy Van G10, 4.3 N, Automatic, 475/M40SECTION 4.3L/5.0L/5.7L Tests W/Codes
- Diagnostic Circuit Check - Testing
- System Performance Check
- Chart A1 - Dwell Fixed Under 10°
- Chart A2 - Dwell Fixed Between 10°-50°
- Chart A3 - Dwell Fixed Over 50°
- Chart A5 - "Check Engine" Light Inoperative
- Chart A6 - No Code 12/"Check Engine" Light Always On
- Code 12 - No Distributor Reference Pulses
- Code 13 - Oxygen Sensor Circuit
- Code 14 - Coolant Sensor Shorted
- Code 15 - Coolant Sensor Open
- Code 21 - TPS Circuit High
- Code 23 - M/C Solenoid Circuit Low
- Code 34 - Differential Pressure (Vacuum) Sensor
- Code 41 - No Distributor Reference Signal
- Code 42 - Electronic Spark Timing (Est)
- Code 43 - Electronic Spark Control (4.3L Only)
- Code 44 - Lean Exhaust Indication
- Code 45 - Rich Exhaust Indication
- Code 51 - Faulty Prom
- Code 54 - M/C Solenoid Circuit Voltage High
- Chart C1 - ECM Replacement Check Chart
- Chart C1E - Vac Sensor
- Chart C2F - TPS Enrichment Check
- Chart C2T - Throttle Kicker (4.3L W/ A/C Only)
- Chart C2T - Throttle Kicker (4.3L W/O A/C Only)
- Chart C3 - Canister Purge Valve Check
- Chart C4A - IGN System (All W/ Integral Coil)
- Chart C4D - Est Performance Check
- Chart C5 - ESC Check (No Code 43)
- Chart C6C - Electric Diverter Valve (EDV) Check
- Chart C7A - EGR Valve (PWM)
- Chart C7C - EGR Valve Check (Non-ECM Controlled)
- Chart C8B - TCC Electrical Diagnosis (All Exc. 4.3L)
- CHART C8C - TCC Electrical Diagnosis (4.3L ONLY)
- Chart C9C - EFE Check
- Park Neutral Switch Diagnosis (Auto Trans Only)
- Crank Signal
- Map Output Check
- Power Steering Pressure Signal
- EGR Valve Check Non-ECM Controlled
- Transmission Converter Clutch (TCC) Elect. Diagnosis
- Shift Light
- A/C Clutch Control
- Wiring Diagram
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.