Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1983SUBURBAN C20, 5.7 M, STANDARDREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSOVERHAUL & TESTING - 700-R4/4L60TRANSMISSION DISASSEMBLYTRANSMISSION END PLAY CHECK
1983 Chevrolet Suburban C20, 5.7 M, Standard
Transmission End Play Check
1983 Chevrolet Suburban C20, 5.7 M, StandardSECTION Transmission End Play Check
NOTE:
Check transmission end play before disassembly. If end play is not within specification, check for damaged components.
- Position transmission with oil pump facing up. Remove one oil pump retaining bolt and washer, and replace it using an 11" bolt and lock nut. Install Pump Remover/End Play Fixture (J-24773-A) and End Play Adapter (J-25022-A) on end of turbine shaft. See Fig 1 .
- Clamp dial indicator on long bolt. Position indicator tip on end play fixture. Zero dial indicator. Pull up on pump remover. Note dial indicator reading. Transmission end play should be .005-.036" (.13-.91 mm). Check for worn components if end play is not within specification.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.