Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1983STEP VAN P30, 5.7 M, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMCARBURETOR - ROCHESTER E4ME 4-BBLADJUSTMENTSAIR VALVE ROD - REAR
1983 Chevrolet Step Van P30, 5.7 M, Standard
Air Valve Rod - Rear
1983 Chevrolet Step Van P30, 5.7 M, StandardSECTION Air Valve Rod - Rear
- Using an outside vacuum source, at least 18 in. Hg, seat secondary (rear) vacuum break diaphragm. Plug purge bleed hole (if equipped) with masking tape. Hole is located in end of diaphragm.
- Make sure air valve is completely closed. Measure clearance between rod and end of slot in lever. Clearance can be checked using a specified drill or pin gauge. See Fig 1.
- Bend rod at point shown to adjust clearance in slot to .025" with vacuum still applied. Remove tape and reconnect vacuum hose to diaphragm.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.