Fuel Injection System - Single Unit TBI: Overhaul: Disassembly: Notes

1983 Chevrolet Citation 4D Hatchback, 2.5 R, AutomaticSECTION Notes
NOTE: Before performing any service on throttle body assembly, it is essential that throttle body be placed on a Holding Fixture (J-9789-118, BT 30-15 or equivalent) to prevent damage to throttle valve. Disassembly of each throttle body unit is the same. DO NOT  interchange components between front and rear units. Mark and identify each component for identification.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.