Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982SUBURBAN C20, 5.7L ENG VIN M, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGPOWER STEERINGPOWER STEERING GEARS - SAGINAW ROTARY VALVEOVERHAULADJUSTER PLUGREASSEMBLY
1982 Chevrolet Suburban C20, 5.7L Eng VIN M, Standard Trans
Adjuster Plug: Reassembly
1982 Chevrolet Suburban C20, 5.7L Eng VIN M, Standard TransSECTION Reassembly
- Press roller bearing into adjuster plug (identification end facing tool) until bearing bottoms on input shaft seal bore. Install input shaft seal with spring in seal facing adjuster plug.
- Install dust seal with lip facing upward into adjuster plug, then install retainer ring. Install adjuster plug "O" ring. Assemble thrust bearing, thrust bearing race, and thrust bearing spacer on adjuster plug. Using a brass or wooden dowel, press bearing retainer into needle bearing bore.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.