Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CITATION 4D HATCHBACK, 2.8L ENG VIN Z, AUTOMATIC TRANS, TRANS MFR CD 125/M34REPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSCOMPUTER COMMAND CONTROLDIAGNOSTIC PROCEDUREDIAGNOSTIC CIRCUIT CHECK
1982 Chevrolet Citation 4D Hatchback, 2.8L Eng VIN Z, Automatic Trans, Trans Mfr CD 125/M34
Diagnostic Circuit Check
1982 Chevrolet Citation 4D Hatchback, 2.8L Eng VIN Z, Automatic Trans, Trans Mfr CD 125/M34SECTION Diagnostic Circuit Check
- If complaint is "CHECK ENGINE" lamp related, this check will lead to most likely problem area, if malfunction exists. Enter diagnostics and record stored trouble codes. Begin diagnosis with lowest numbered code which is displayed and refer to appropriate trouble code chart.
- If code "51" is displayed, refer to PROM removal and installation in this article for diagnosis of this code.
- If codes "54" or "55" are displayed with another code, always refer to diagnostic chart for code "54" or "55" first, then proceed to next lowest numbered code.NOTE: Any time codes "51", "54" or "55" are displayed with another code, start with "50-series" code first, then proceed to next lowest numbered code.
- If codes "13" and "21", "14" and "21" or "15" and "21" are displayed, start with code "21" first, then proceed to code "13", "14" or "15".
- On 2.8L engine with manual transmission, if codes "13" and "34", "14" and "34" or "15" and "34" are displayed, start with code "34" first, then proceed to code "13", "14" or "15".
- If "intermittent failure" codes "13", "15", "24", "35", "44", "45" or "55" are displayed, use diagnostic chart for corresponding "hard failure" code.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.