Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1982CHEVY VAN G30, 4.1L ENG VIN D, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)STEERINGMANUAL STEERINGPOWER STEERING GEARS - SAGINAW RECIRCULATING BALLADJUSTMENTWORM BEARING PRELOAD
1982 Chevrolet Chevy Van G30, 4.1L Eng VIN D, Standard Trans
Worm Bearing Preload
1982 Chevrolet Chevy Van G30, 4.1L Eng VIN D, Standard TransSECTION Worm Bearing Preload
- Loosen over-center preload adjuster. Tighten worm bearing adjuster until all end play has been removed; then loosen 1/4 turn and tighten lock nut. Turn worm shaft carefully to either stop. Do not jam into stop as damage to gear could result. Rotate worm shaft back from stop about 1/2 turn.
- Using an INCH lbs. torque wrench, measure the torque required to keep worm shaft in motion about one revolution. Adjust rotating torque with worm bearing adjuster. Tighten lock nut, and recheck turning torque. Adjust as necessary. Perform over-center preload adjustment procedure.
WORM BEARING PRELOAD
| Application | INCH Lbs. (N.m) |
|---|---|
| All Manufacturers | 5-8 (.6-.9) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.