Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
"K" Models
Raise vehicle on hoist and place jack stands just inside front springs. Disconnect connecting rod and tie rod to allow independent movement of each steering knuckle. Apply fish scale to tie rod mounting hole of steering knuckle arm. With knuckle assembly in straight ahead position, determine right angle pull required to keep knuckle assembly turning after initial breakaway. Effort must not exceed 25 lbs. in either direction.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.