Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1980FORWARD CONTROL 5.7L ENG VIN M, AUTOMATIC TRANS, TRANS MFR CD 400/M40REPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESWHEEL HUBSFRONT WHEEL BEARING ADJUSTMENTADJUSTMENTJEEP"CJ" MODELS
1980 Chevrolet Forward Control 5.7L Eng VIN M, Automatic Trans, Trans Mfr CD 400/M40
"CJ" Models
1980 Chevrolet Forward Control 5.7L Eng VIN M, Automatic Trans, Trans Mfr CD 400/M40SECTION "CJ" Models
Install inner lock washer and adjusting nut. Tighten nut to 50 ft. lbs. while rotating rotor. Now back off nut 1/3 turn. Install outer lock washer and nut. Tighten nut to 50 ft. lbs. Bend lock washer lip over nut.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.