Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1977CAMARO BASE, 4.1L ENG VIN D, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEIGNITION SYSTEMDISTRIBUTOR SPECIFICATIONSPRESTOLITE DISTRIBUTOR ADVANCE SPECIFICATIONS
1977 Chevrolet Camaro Base, 4.1L Eng VIN D, Automatic Trans
PRESTOLITE Distributor Advance Specifications
1977 Chevrolet Camaro Base, 4.1L Eng VIN D, Automatic TransSECTION PRESTOLITE Distributor Advance Specifications
NOTE:
FOR ENGINE RPM AND DEGREES, MULTIPLY SPECIFICATIONS BELOW BY 2.
| Distributor Part No. | Rot(1) | Centrifugal Advance (Distr. Degrees & RPM) | Vacuum Advance (Distr. Deg. & In. of Hg.) | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Deg. | RPM | Deg. | RPM | Deg. | RPM | Deg. | In. Hg. | Deg. | In. Hg. | ||||
| IDJ-4001E | C | 0 | 350-550 | 8 | 600-850 | 13 | 2200 | 0 | 4-6 | 17 | 11 1/2 | ||
| IDJ-4001F | C | 0 | 350-550 | 8 | 650-1200 | 9/2 | 2200 | 0 | 4-6 | 17 | 11 1/2 | ||
| IDJ-4001G | C | 0 | 350-550 | 8 | 600-775 | 15 1/2 | 2200 | 0 | 5-7 | 17 | 13 | ||
| IDJ-4001H | C | 0 | 350-550 | 8 | 500-700 | 12 | 2200 | 0 | 5-7 | 17 | 13 | ||
| IDJ-4002F | C | 0 | 350-550 | 8 | 800-1000 | 11 | 2200 | 0 | 5-7 | 18 | 13 | ||
|
|||||||||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.