Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Evaporation Systems: Description
The fuel evaporation control system is designed to prevent raw fuel vapors from escaping into the atmosphere. This is a closed system (not vented) and consists of a special fuel tank with "dome" design and/or a liquid/vapor separator, a pressure/vacuum fuel cap, an orifice valve (Ford), a rollover valve, a liquid check valve (Jeep), a purge valve, 1 or 2 charcoal canisters and necessary vapor and vacuum hoses.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.