Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1976BLAZER C10, 4.1L ENG VIN D, AUTOMATIC TRANSLABOR TIMESBRAKESMECHANICAL - HYDRAULICBRAKE SYSTEM (COMPLETE)REMOVE & REPLACE
1976 Chevrolet Blazer C10, 4.1L Eng VIN D, Automatic Trans
Brake System (Complete): Remove & Replace
1976 Chevrolet Blazer C10, 4.1L Eng VIN D, Automatic TransSECTION Remove & Replace
Includes: Replace Calipers and/or Wheel Cylinders, Brake Shoes and/or Pads. Clean, lube and/or replace Brake Hardware as necessary. Inspect Master Cylinder, all Hoses and bleed Brake System. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All Wheels | 3.0 | B | ||
| Combination Procedure: AXLE BEARING: Replace: | ||||
| C10, Rear,Both | 0.8 | B | ||
| C10, Rear,One Side | 0.6 | B | ||
| Combination Procedure: AXLE SEAL: Replace: Semi-Floating Axle. | ||||
| Rear,Both | 0.8 | B | ||
| Rear,One Side | 0.6 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each | 0.2 | B | ||
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: | ||||
| RWD, Front,Each | Includes: Repack Wheel Bearings. | 0.4 | B | |
| RWD, Rear,Each | Includes: Repack Wheel Bearings. | 0.7 | B | |
| Combination Procedure: DISC ROTOR: Replace: | ||||
| RWD, Each | Includes: Repack Wheel Bearings. | 0.4 | B | |
| Combination Procedure: DRUM: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: WHEEL BEARING: Repack: Both Sides. | ||||
| RWD, Front | 0.8 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| RWD, Front,One Side | Includes: Repack Wheel Bearings. | 0.5 | B | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.