Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1972CHEVELLE BASE, NOT AVAILABLE, 7.4L ENG VIN V, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSPOWER SEAT CONTROLSCOMPONENT REPLACEMENTDRIVE MOTOR4-WAY BUCKET SEAT
1972 Chevrolet Chevelle Base, Not Available, 7.4L Eng VIN V, Not Available Trans
4-Way Bucket Seat
1972 Chevrolet Chevelle Base, Not Available, 7.4L Eng VIN V, Not Available TransSECTION 4-Way Bucket Seat
- If motor can be operated, raise seat to full up position. Disconnect wire harness connector from motor relay.
- At front of seat remove motor and transmission drive belt cover. Remove drive belt from motor and transmission drive pulleys (pulleys may be removed from either motor or transmission by pulling them off shaft).
- Remove screws under motor and transmission support attaching motor to support and remove motor from under seat.
- To install, reverse removal procedure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.