SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1972CHEVELLE BASE, NOT AVAILABLE, 7.4L ENG VIN V, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSPOWER TRUNK LID LOCKSREMOVAL & INSTALLATIONTRUNK LOCK CYLINDER
1972 Chevrolet Chevelle Base, Not Available, 7.4L Eng VIN V, Not Available Trans

Trunk Lock Cylinder

1972 Chevrolet Chevelle Base, Not Available, 7.4L Eng VIN V, Not Available TransSECTION Trunk Lock Cylinder

Disengage tab on lock anchor plate from lock cylinder retainer. Pull slotted retainer as necessary to disengage the retainer from the lock cylinder, then remove lock cylinder and gasket from rear end panel. To install, reverse removal procedure.

CAUTION: Insure that lock cylinder shaft engages with lock, and gasket mates properly with outer panel to form a watertight seal.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.