Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Vacuum Release Unit
System consists of a side action snap bolt lock with a vacuum release unit attached to unlock the lock upon vacuum introduction. Vacuum is stored in reservoir in engine compartment and is controlled by a switch located in glove box. When switch is actuated, vacuum enters into the line from the storage tank and extends to the release unit, thereby, unlocking the lid lock. This is only an unlocking system, therefore, the rear compartment lid must be closed manually.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.