Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1971CHEVELLE BASE, 2D CONVERTIBLE, 5.0L ENG, ENG CD CCC, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTSEATSPOWER SEAT CONTROLSCOMPONENT REPLACEMENTSEAT ADJUSTER ASSEMBLYVERTICAL TRAVEL (FRONT OR REAR)
1971 Chevrolet Chevelle Base, 2D Convertible, 5.0L Eng, Eng CD CCC, Not Available Trans
Vertical Travel (Front Or Rear)
1971 Chevrolet Chevelle Base, 2D Convertible, 5.0L Eng, Eng CD CCC, Not Available TransSECTION Vertical Travel (Front Or Rear)
- Operate control switch until one adjuster has reached full up position at both front and rear. Disconnect both front and rear vertical drive cables from this adjuster.
- Operate switch until other adjuster reaches full up position at both front and rear.
- Connect previously removed vertical drive cables. Check vertical travel by operating adjusters through one or two complete cycles.
- Above operation may be repeated on an "as required" basis if adjusters not in phase after test cycling.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.