Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Oldsmobile Cutlass, Omega (1973)
Pedal freeplay should be 3/4 - 1 3/4" on Cutlass or 7/8 - 1 1/2" on Omega. To adjust, loosen lower push rod swivel. Disconnect pedal return spring. With clutch pedal against stop, push clutch fork until throwout bearing lightly contacts pressure plate fingers. Install push rod swivel in gauge hole (upper hole). Increase length of rod until all lash is removed from system. Reinstall rod in lower hole, being careful not to change rod length. Pedal freeplay should be as specified.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.