Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1969 Comet, Falcon, Fairlane, Montego: Replacement
Falcon models, remove both grille upper supports. All models, remove hood latch and support assembly. Disconnect evaporator-to-condenser hose and compressor-to-condenser hose at receiver tank and condenser, then remove clamp holding hoses at radiator support. Disconnect condenser from radiator front and remove condenser and Receiver-Drier. To install reverse removal procedure.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.