Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Idle Stop Solenoid Position
With throttle stopscrew set for approximately 575 RPM idle speed (normal setting), loosen clampscrew and slide solenoid away from throttle lever. Energize solenoid (or hold solenoid plunger in outer extended position), adjust solenoid stopscrew so that head of screw is 7/8"±1/16" out of solenoid body (see Figure), move solenoid assembly inward until screw lightly contacts throttle lever, make certain electtical connection is positioned 90° inward and tighten solenoid clampscrew. Back off throttle stopscrew so that throttle valves are completely closed.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.