Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1967CAPRICE 2D HARDTOP, 5.3L ENG, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALENGINE REMOVALVEGA 4 CYL. ENGINE1971-73
1967 Chevrolet Caprice 2D Hardtop, 5.3L Eng, Not Available Trans
VEGA 4 CYL. Engine: 1971-73
1967 Chevrolet Caprice 2D Hardtop, 5.3L Eng, Not Available TransSECTION 1971-73
- Disconnect both battery cables, all water and vacuum emission control hoses and disconnect all wires from sending units, switches and solenoids.
- Remove radiator panel or shroud. If equipped with A/C, move compressor forward and rest on frame forward brace without disconnecting lines. Position power steering pump out of way without disconnecting hoses.
- Disconnect exhaust pipe at manifold. Remove flywheel dust cover or converter under pan. With Auto. Trans., remove converter retaining bolts and nuts and install converter safety strap.
- Remove converter housing or flywheel housing bolts. Loosen engine front mounts at frame attachment. Lower car to floor and install floor jack at suitable support under transmission.
- Using suitable lifting tackle, slightly raise engine to take weight off engine mounts and remove engine front mount retaining bolts. Pull engine forward to clear transmission and slowly lift engine from car.
VEGA TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. |
|---|---|
| Engine Front Mount Stud to Block | 20 |
| Crossmember-to-Frame Bolts | 28 |
| Crossmember-to-Mount Bolts | 26 |
| Transmission Mount-to-Rear Extension | 30 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.