Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Bearing - Drive End Frame
To remove, detach retainer plate bolts, then separate retainer plate and seal assembly from end frame. Press bearing out using suitable tube or pipe on inner race (5.5" series) or outer race (6.2" series). If bearing is not pre-lubricated type, fill 1/4 full with Delco-Remy No. 1948971 or equivalent.
To install, press into end frame using suitable tool, as in removal, which fits over outer race.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.