Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1966CHEVY II BASE, 2D SEDAN, 2.5L ENG, AUTOMATIC TRANS, TRANS MFR CD THM400REPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONDRIVELINE/AXLESMAP - DRIVE TRAIN & TRANSMISSIONDRIVETRAIN AND TRANSMISSIONCLUTCH SLAVE CYLINDERS (CONCENTRIC)
1966 Chevrolet Chevy II Base, 2D Sedan, 2.5L Eng, Automatic Trans, Trans Mfr CD THM400
Clutch Slave Cylinders (Concentric)
1966 Chevrolet Chevy II Base, 2D Sedan, 2.5L Eng, Automatic Trans, Trans Mfr CD THM400SECTION Clutch Slave Cylinders (Concentric)
| Condition | Code | Procedure |
|---|---|---|
| Bearing rough when rotated as an assembly | B | Require replacement |
| Bearing seized | A | Require replacement |
| Bleeder pipe leaks | A | Require repair or replacement |
| Carrier assembly worn, affecting performance | A | Require replacement |
| Collar broken | A | Require replacement |
| Cracked | B | Require replacement |
| Housing leaks | A | Require replacement |
| Inoperative | A | Require replacement |
| Release binding | A | Require replacement |
| Spring broken | A | Require replacement |
| Threads damaged | A | Require repair or replacement |
| Threads stripped (threads missing) | A | Require replacement |
| Worn, affecting performance | A | Require replacement |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.