Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET1965CHEVY II BASE, 2D SEDAN, 2.5L ENG, NOT AVAILABLE TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE MECHANICALMECHANICALENGINE REMOVALENGINE MOUNTING ADJUSTMENT1964-65 ENGINES
1965 Chevrolet Chevy II Base, 2D Sedan, 2.5L Eng, Not Available Trans
1964-65 Engines
1965 Chevrolet Chevy II Base, 2D Sedan, 2.5L Eng, Not Available TransSECTION 1964-65 Engines
CAUTION:
Position of support must NOT be changed by removal of shims to move support sideways. Whenever support is removed, the number and location of shims at each end of support must be noted, and shims must be reinstalled exactly where found.
- Loosen exhaust pipes at manifolds. Loosen four engine mount to frame bolts.
- Make sure that transmission support to frame shims are in original position and tighten al I support to frame, support to mount, and mount to rear bearing retainer bolts.
- Raise engine slightly to allow mounts to normalize. Lower engine and tighten engine mount to frame bolts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.