SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013ESCALADE LUXURY, RWDREPAIR AND DIAGNOSISENGINE PERFORMANCEENGINE CONTROL SYSTEMSENGINE CONTROLS/FUEL - 5.3L, 6.0L, 6.2L - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSEVAPORATIVE EMISSION SYSTEM HOSE/PIPE REPLACEMENT (2500 LWB - 98.4L (26 GAL) TANK-FRONT)REMOVAL PROCEDURE
2013 Cadillac Escalade Luxury, RWD

Removal Procedure

2013 Cadillac Escalade Luxury, RWDSECTION Removal Procedure
IMPORTANT:

Clean all fuel and evaporative emission (EVAP) line connections and surrounding areas prior to disconnecting the lines in order to avoid possible fuel and/or EVAP system contamination.

    Fig 1: View Of Fuel Tank Shield & Retainers
    GM1705654Courtesy of GENERAL MOTORS COMPANY
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (2500 LWB - 98.4L (26 gal) Tank Front) .
  2. Remove the fuel tank shield retainers (1) and shield (2).
    3. Fig 2: View Of Fuel Tank Clips
    GM1705656Courtesy of GENERAL MOTORS COMPANY
  3. Remove the EVAP line from the fuel tank clip (1).
  4. Open the fuel tank clips (2-7) and remove the fuel/EVAP lines from the clips.
  5. Disconnect the fuel/EVAP line quick connect fittings from the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
    6. Fig 3: View Of Fuel Tank EVAP Lines
    GM1705659Courtesy of GENERAL MOTORS COMPANY
  6. Remove the fuel/EVAP lines from the fuel tank.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.