Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013ESCALADE ESV PLATINUM, RWDREPAIR AND DIAGNOSISELECTRICALWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - MEMORY SEAT MODULE X5 (AN3) TO YAW SENSORCOMPONENT CONNECTOR END VIEWSTURN SIGNAL/MULTIFUNCTION SWITCH X2
2013 Cadillac Escalade ESV Platinum, RWD
Turn Signal/Multifunction Switch X2
2013 Cadillac Escalade ESV Platinum, RWDSECTION Turn Signal/Multifunction Switch X2
Connector Part Information
|
Terminal Part Information
|
Turn Signal/Multifunction Switch X2
| Pin | Wire | Circuit | Function |
|---|---|---|---|
| A | 0.35 YE/BK | 307 | Headlamp Switch Flash to Pass Signal |
| B-C | - | - | Not Used |
| D | 0.35 BK/WH | 1851 | Ground |
| E | 0.35 YE | 525 | Headlamp Dimmer Switch Low Beam Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.