Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013ESCALADE ESV PLATINUM, RWDREPAIR AND DIAGNOSISELECTRICALMOTORS, SWITCHES, RELAYSELECTRICAL COMPONENT LOCATOR - INSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSINSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSINSTRUMENT PANEL COMPONENTS (Y91)
2013 Cadillac Escalade ESV Platinum, RWD
Instrument Panel Components (Y91)
2013 Cadillac Escalade ESV Platinum, RWDSECTION Instrument Panel Components (Y91)
Instrument Panel Components (Y91)
| Component Name | Callout |
|---|---|
| Turn Signal/Multifunction Switch | 1 |
| Automatic Transmission Shift Lever | 2 |
| Ambient Light/Sunload Sensor (CJ2) | 3 |
| Speaker- Center I/P (UQA or UQS) | 4 |
| Clock (Z75) | 5 |
| Radio | 6 |
| Inflatable Restraint I/P Module | 7 |
| Traction Control Switch (Z75) | 8 |
| HVAC Control Module | 9 |
| Multifunction Switch- I/P | 10 |
| Driver Information Center (DIC) Switch (Z75) | 11 |
| Noise Compensation Microphone | 12 |
| Inflatable Restraint Steering Wheel Module | 13 |
| Steering Wheel/Column Tilt Switch (N48) | 14 |
| Transfer Case Shift Control Switch (NQH) | 15 |
| Headlamp and Panel Dimmer Switch | 16 |
| Data Link Connector (DLC) | 17 |
| Headlamp and Panel Dimmer Switch | 18 |
| Instrument Panel Cluster (IPC) | 19 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.