SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013ESCALADE ESV PLATINUM, RWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSELECTRONIC SUSPENSION CONTROL MODULE PROGRAMMING AND SETUPREPLACE AND PROGRAM ECU OR REPROGRAM ECU
2013 Cadillac Escalade ESV Platinum, RWD

Replace and Program ECU or Reprogram ECU

2013 Cadillac Escalade ESV Platinum, RWDSECTION Replace and Program ECU or Reprogram ECU

To program a replacement or an existing ECU, perform the following procedure:

  1. Install EL-49642  SPS programming support tool.
  2. Access the Service Programming System (SPS) and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select ESCM - Electronic Suspension Control Module and follow the on-screen instructions.
  4. At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
  5. With a scan tool, perform the suspension system calibration procedure. Refer to Suspension Position Calibration (Without Z95) , Suspension Position Calibration (With Z95) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.