Installation Procedure

2013 Cadillac CTS V, 2D Coupe, Automatic TransSECTION Installation Procedure
  1. Install the rear window into the opening.
  2. Connect the rear window defogger electrical connectors.
  3. Connect the rear window radio antenna, diversity antenna, and the television antenna. Refer to Radio Antenna Module Replacement (Wagon) , Radio Antenna Module Replacement (Sedan) , Radio Antenna Module Replacement (Coupe) , and Television Antenna Cable Replacement
  4. Check the radio and OnStar® system to verify reception.
  5. Close the rear compartment lid.
  6. Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.