Theft Deterrent Module Replacement

2013 Cadillac CTS V, 2D Coupe, Automatic TransSECTION Theft Deterrent Module Replacement
Fig 1: Theft Deterrent Module, Ignition Lock Cylinder & Bolts
GM1969382Courtesy of GENERAL MOTORS COMPANY
Theft Deterrent Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the steering column shrouds. Refer to Steering Column Shroud Replacement (Without Key Release Lever Knob) , Steering Column Shroud Replacement (With Key Release Lever Knob) .
1 Ignition Lock Cylinder
Refer to Ignition Lock Cylinder Replacement
2 Theft Deterrent Module Bolt/Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
2 N.m (18 lb in)
3 Theft Deterrent Module

Procedure

  1. Disconnect the electrical connector.
  2. Refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.