Communication Interface Module Replacement

2013 Cadillac CTS V, 2D Coupe, Automatic TransSECTION Communication Interface Module Replacement
Fig 1: Identifying Communication Interface Module & Mounting Components
GM2132753Courtesy of GENERAL MOTORS COMPANY
Communication Interface Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the instrument panel compartment. Refer to Instrument Panel Compartment Replacement (Right Hand Drive) , Instrument Panel Compartment Replacement (Left Hand Drive) .
1 Communication Interface Module Nut (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (79 lb in)
2 Communication Interface Module Bolt Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
2.5 N.m (22 lb in)
3 Communication Interface Module

Procedure

  1. Disconnect the electrical connections.
  2. If replacing the communication interface module be sure to transfer Bluetooth antenna, if equipped.
  3. For programming and set up procedures, refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.