Pedestrian Impact Detection Module Replacement

2013 Cadillac CTS V, 2D Coupe, Automatic TransSECTION Pedestrian Impact Detection Module Replacement
Fig 1: Pedestrian Impact Detection Module & Bolts
GM1969850Courtesy of GENERAL MOTORS COMPANY
Pedestrian Impact Detection Module Replacement

Callout Component Name
Preliminary Procedure 
Remove the instrument panel (I/P) compartment assembly. Refer to Instrument Panel Compartment Replacement (Right Hand Drive) , Instrument Panel Compartment Replacement (Left Hand Drive) .
1 Pedestrian Impact Detection Module Bolt/Screw (Qty: 3)
CAUTION:

Refer to Fastener Caution .


Tighten 
10 N.m (89 lb in)
2 Pedestrian Impact Detection Module

Procedure

  1. Disconnect the electrical connectors.
  2. Refer to Control Module References for programming and set up procedures.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.