Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013CTS V, 2D COUPE, AUTOMATIC TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINTERIOR/ILLUMINATION LIGHTSLIGHTING SYSTEM - REPAIR INSTRUCTIONSREPAIR INSTRUCTIONSBRAKE PEDAL POSITION SENSOR CALIBRATIONCALIBRATION PROCEDURE
2013 Cadillac CTS V, 2D Coupe, Automatic Trans
Calibration Procedure
2013 Cadillac CTS V, 2D Coupe, Automatic TransSECTION Calibration Procedure
- Apply the parking brake.
- Place the transmission in the PARK position.
- Install a scan tool.
- Clear all BCM DTCs before proceeding.
- Navigate to the Vehicle Control Systems menu.
- Select Module Setup menu item.
- Select BCM menu item.
- Select the BPP Sensor Calibration procedure and follow the directions displayed on the screen.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.