Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Keyless Entry Transmitter
The keyless entry transmitters are not only used to passively or actively lock and unlock the vehicle, they are also used to allow vehicle starting. If the RCDLR does not receive a valid RF response after the transmitter is challenged, the RCDLR will not send a fuel enable message to the ECM. If the RCDLR is unable to establish communication with the transmitter during an attempted engine start, the ELECTRONIC KEY NOT DETECTED message will display on the driver information center (DIC).
When any one of the programmed key fobs are challenged by pushing in the control knob, it will passively send a RF signal to the RCDLR. The RCDLR will then send a serial data message to the ECM to enable engine starting.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.