Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013ATS 2.0L ENG VIN X, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSWIRING SYSTEMS AND POWER MANAGEMENT - COMPONENT CONNECTOR END VIEWS - Q37RF TO X92COMPONENT CONNECTOR END VIEWSS42 HEADLAMP LEVELING SWITCH (TR6)
2013 Cadillac ATS 2.0L Eng VIN X, AWD
S42 Headlamp Leveling Switch (TR6)
2013 Cadillac ATS 2.0L Eng VIN X, AWDSECTION S42 Headlamp Leveling Switch (TR6)
Connector Part Information
|
Terminal Part Information
| Terminal Type ID | Terminated Lead | Diagnostic Test Probe | Terminal Removal Tool | Service Terminal | Tray | Core Crimp | Insulation Crimp |
|---|---|---|---|---|---|---|---|
| I | 13587474 | J-35616-64B (L-BU) | J-38125-215A | Not Available | Not Available | P | P |
S42 Headlamp Leveling Switch (TR6)
| Pin | Size | Color | Circuit | Function | Terminal Type ID | Option |
|---|---|---|---|---|---|---|
| 1 | 0.5 | BK | 1350 | Ground | I | TR6 |
| 2 | 0.35 | BN/YE | 189 | Headlamp Leveling Motor Supply Voltage | I | TR6 |
| 3-4 | - | - | - | Not Occupied | - | - |
| 5 | 0.5 | YE | 6817 | LED Backlight Dimming Control | I | TR6 |
| 6 | 0.35 | VT/GY | 539 | Run/Crank Ignition 1 Voltage | I | TR6 |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.