Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2013ATS 2.0L ENG VIN X, AWDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSELECTRICAL COMPONENT LOCATOR - INSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSINSTRUMENT PANEL/CENTER CONSOLE COMPONENT VIEWSHVAC MODULE COMPONENTS
2013 Cadillac ATS 2.0L Eng VIN X, AWD
HVAC Module Components
2013 Cadillac ATS 2.0L Eng VIN X, AWDSECTION HVAC Module Components
HVAC Module Components
| Items |
|---|
| 1: B7J Air Temperature Sensor - Duct Right Upper B7J Air Temperature Sensor - Duct Right Upper |
| 2: M37 Mode Door Actuator M37 Mode Door Actuator |
| 3: M6L Air Temperature Door Actuator - Left M6L Air Temperature Door Actuator - Left |
| 4: M6R Air Temperature Door Actuator - Right M6R Air Temperature Door Actuator - Right |
| 5: M46 Air Recirculation Door Actuator M46 Air Recirculation Door Actuator |
| 6: B39 A/C Evaporator Temperature Sensor B39 A/C Evaporator Temperature Sensor |
| 7: M8 Blower Motor M8 Blower Motor |
| 8: B7E Air Temperature Sensor - Duct Right Lower B7E Air Temperature Sensor - Duct Right Lower |
| 9: B7D Air Temperature Sensor - Duct Left Lower B7D Air Temperature Sensor - Duct Left Lower |
| 10: B7H Air Temperature Sensor - Duct Left Upper B7H Air Temperature Sensor - Duct Left Upper |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.