SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISHEATING, VENTILATION & A/C (HVAC)HVAC CONTROL SYSTEMSHEATING, VENTILATION, AND AIR CONDITIONINGREPAIR INSTRUCTIONSAUXILIARY BLOWER CONTROL MODULE REPLACEMENT
2011 Cadillac Escalade Base, AWD

Auxiliary Blower Control Module Replacement

2011 Cadillac Escalade Base, AWDSECTION Auxiliary Blower Control Module Replacement
Fig 1: Auxiliary Blower Control Module
GM1681989Courtesy of GENERAL MOTORS CORP.
Auxiliary Blower Control Module Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the right rear quarter trim panel. Refer to Rear Quarter Trim Panel Replacement - Right Side (Extended Wheelbase) , Rear Quarter Trim Panel Replacement - Right Side (Standard Wheelbase) .
  2. Disconnect the blower motor control module electrical connector.
1 Screw, Blower Motor Resistor (Qty: 2)
CAUTION:

Refer to Fastener Caution .


Tighten 
1.5 N.m (13 lb in)
2 Module, Blower Motor Control
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.