SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 920 (AUTOMATIC TRANSMISSION - ALLISON - REMOVAL & INSTALLATION, SERVICE, OVERHAUL, TROUBLESHOOTING & DIAGNOSIS)ON-VEHICLE REPAIR INSTRUCTIONSAUTOMATIC TRANSMISSION RANGE SELECTOR LEVER CABLE REPLACEMENTINSTALLATION PROCEDURE
2011 Cadillac Escalade Base, AWD

Installation Procedure

2011 Cadillac Escalade Base, AWDSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the cable to the vehicle.
    2. Fig 1: View Of Cable Grommet At Floor Panel
    GM858974Courtesy of GENERAL MOTORS CORP.
  2. Install the cable grommet to the floor panel.
    3. Fig 2: View Of Range Selector Cable
    GM1774421Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.