Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
EBCM Programming and Setup - Hybrid
If the electronic brake control module (EBCM) is replaced or needs reprogrammed, the following procedures must be performed:
- EBCM Reprogramming-Refer to Service Programming System (SPS) .
The vehicle must be at least 35° (1.6° C) or warmer before performing the set up procedures below. Use a contact thermometer or an infrared temperature gun to measure the temperature of the EHCU. The EBCM Relearn procedure should not be performed if the ECHU temp is below 35° degrees F (1.6° C) and the brake pedal should remain in the rest position, brakes not applied.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.