SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1465 (DISC BRAKE SYSTEM)SPECIFICATIONSDISC BRAKE COMPONENT SPECIFICATIONS
2011 Cadillac Escalade Base, AWD

Disc Brake Component Specifications

2011 Cadillac Escalade Base, AWDSECTION Disc Brake Component Specifications
WARNING: This page is about a different car, the 2009 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
Application Specification
Metric English
Front Brakes
  • Brake Pad Lining Minimum Thickness
 2.0 mm 0.080 in
  • Brake Rotor Diameter
 296.00 mm 11.654 in
  • Brake Rotor Discard Thickness*
 27.4 mm 1.079 in
  • Maximum Allowable Lateral Runout
 0.06 mm 0.002 in
  • Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
Rear Brakes
  • Brake Pad Lining Minimum Thickness
 2.0 mm 0.080 in
  • Brake Rotor Diameter
 191 mm 7.520 in
  • Rotor Discard Thickness *
 18.4 mm 0.724 in
  • Maximum Allowable Lateral Runout
 0.06 mm 0.002 in
  • Maximum Allowable Scoring
 1.50 mm 0.059 in
  • Maximum Allowable Thickness Variation
 0.025 mm 0.001 in
* All brake rotors have a discard dimension cast into them. Replace any rotor that does not meet this specification. After refinishing the rotor, replace any rotor that does not meet the minimum thickness specifications.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.