Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 1319 (PROGRAMMING AND SETUP - ALL SYSTEMS)REPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE PROGRAMMING AND SETUPEBCM PROGRAMMING AND SETUP - HYBRID
2011 Cadillac Escalade Base, AWD
EBCM Programming and Setup - Hybrid
2011 Cadillac Escalade Base, AWDSECTION EBCM Programming and Setup - Hybrid
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The battery must be able to maintain a charge during the programming. Only use approved Midtronics PSC-550 charger/maintainer or equivalent to maintain proper battery voltage during programming.
If the electronic brake control module (EBCM) is replaced or needs reprogrammed, the following procedures must be performed:
- EBCM Reprogramming - Refer to Service Programming System (SPS) .
NOTE:
The vehicle must be at least 35° (1.6° C) or warmer before performing the set up procedures below. Use a contact thermometer or an infrared temperature gun to measure the temperature of the EHCU. The EBCM Relearn procedure should not be performed if the ECHU temp is below 35° degrees F (1.6° C) and the brake pedal should remain the rest position, brakes not applied.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.