Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWSREPAIR INSTRUCTIONSWINDSHIELD SIDE REVEAL MOLDING REPLACEMENT

2011 Cadillac Escalade Base, AWD

Windshield Side Reveal Molding Replacement

2011 Cadillac Escalade Base, AWDSECTION Windshield Side Reveal Molding Replacement

Fig 1: Window Side Reveal Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open the front door on the side the reveal molding is being serviced. Pull the door auxiliary weatherstrip up to the roof header. Remove the air inlet grille panel end cap.
1	Reveal Molding Nut
2	Windshield Side Reveal Molding TIP: Upon installation, tuck the bottom edge of the reveal molding under the end cap of the air inlet grille panel prior to the screw installation.
3	Windshield Side Reveal Molding Screw (Qty: 5) CAUTION: Refer to Fastener Caution . Tighten 2 N.m (18 lb in)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.