SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWSREPAIR INSTRUCTIONSREAR SIDE DOOR WINDOW REGULATOR REPLACEMENT (POWER)
2011 Cadillac Escalade Base, AWD

Rear Side Door Window Regulator Replacement (Power)

2011 Cadillac Escalade Base, AWDSECTION Rear Side Door Window Regulator Replacement (Power)
Fig 1: Rear Side Door Power Window Regulator
GM1673176Courtesy of GENERAL MOTORS CORP.
Rear Side Door Window Regulator Replacement (Power)

Callout Component Name
WARNING:

Refer to SIR Warning .

Preliminary Procedures

  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Position the rear door window approximately half way down in the door.
  3. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement (Extended Wheelbase) , Rear Side Door Trim Panel Replacement (Standard Wheelbase) .
  4. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
1 Rear Side Door Window Regulator Bolt (Qty: 5)
CAUTION:

Refer to Fastener Caution .

  1. Tape the window to the door frame to prevent it from moving.
  2. Loosen the 2 bolts that attach the window to the window regulator.

Tighten 
9 N.m (80 lb in)
2 Rear Side Door Window Regulator
  1. Disconnect the electrical connector.
  2. Transfer the power window motor to the new regulator. Refer to Rear Side Door Window Regulator Motor Replacement .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.