Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWSREPAIR INSTRUCTIONSFRONT SIDE DOOR WINDOW REAR CHANNEL REPLACEMENT

2011 Cadillac Escalade Base, AWD

Front Side Door Window Rear Channel Replacement

2011 Cadillac Escalade Base, AWDSECTION Front Side Door Window Rear Channel Replacement

Fig 1: Front Side Door Window Channels

Courtesy of GENERAL MOTORS CORP.

Callout

Component Name

Preliminary Procedures

Position the door window as needed for service.
Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .

Front Door Window Run Channel Rear Bolt

CAUTION:

Refer to Fastener Caution .

Tighten
10 N.m (89 lb in)

Front Door Window Rear Run Channel
TIP: Raise the door window to the fully close position to gain access the run channel.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.