Circuit/System Verification

2011 Cadillac Escalade Base, AWDSECTION Circuit/System Verification
  1. Ignition ON, command the rear window wiper ON and OFF by using the rear wiper switch. The rear window wiper should turn ON and OFF when changing between commanded states.
  2. Observe the scan tool Ext. Trunk/Liftglass Relay. Sw parameter while pressing the liftgate window release switch. The parameter should change from Inactive to active.
    • If the parameter does not change, refer to Liftglass Release Switch Malfunction.
  3. Command the liftglass latch to release the liftglass by pressing the liftgate window release switch. The liftglass latch should release the liftglass.
    • If the liftglass latch does not release the liftglass, refer to Liftglass Latch Assembly Malfunction.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.