SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSKEYLESS ENTRY SYSTEM AND REMOTE FUNCTIONSREPAIR INSTRUCTIONSREMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT (AVALANCHE/ESCALADE EXT)
2011 Cadillac Escalade Base, AWD

Remote Control Door Lock Receiver Replacement (Avalanche/Escalade EXT)

2011 Cadillac Escalade Base, AWDSECTION Remote Control Door Lock Receiver Replacement (Avalanche/Escalade EXT)
Fig 1: Remote Control Door Lock Receiver (Avalanche/Escalade EXT)
GM2164135Courtesy of GENERAL MOTORS CORP.
Remote Control Door Lock Receiver Replacement (Avalanche/Escalade EXT)

Callout Component Name

Preliminary Procedures

  1. Disable roof rail SIR system. Refer to SIR Disabling and Enabling .
  2. Remove body side lock pillar garnish molding. Refer to Body Lock Pillar Garnish Molding Replacement (Standard Wheelbase) , Body Lock Pillar Garnish Molding Replacement (Avalanche/Escalade EXT) , Body Lock Pillar Garnish Molding Replacement (Extended Wheelbase) .
  3. Remove rear upper garnish molding. Refer to Rear Upper Garnish Molding Replacement (Avalanche/Escalade EXT) .
1 Remote Control Door Lock Receiver

Procedure

  1. The module slides and snaps into the body structure.
  2. Disconnect the antenna and electrical connection.
  3. If a replacement module is installed, program the module. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.