Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCADILLAC2011ESCALADE BASE, AWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSWINDSHIELD WIPER ARM REPLACEMENT (CONVENTIONAL)
2011 Cadillac Escalade Base, AWD
Windshield Wiper Arm Replacement (Conventional)
2011 Cadillac Escalade Base, AWDSECTION Windshield Wiper Arm Replacement (Conventional)
Windshield Wiper Arm Replacement (Conventional)
| Callout | Component Name |
|---|---|
|
Procedure
|
|
| 1 | Windshield Washer Arm Finish Cap TIP: Use a small flat-bladed tool to remove the finish cap. |
| 2 | Windshield Washer Arm Nut
CAUTION:
Refer to Fastener Caution . TIP: Hold the wiper blade arm tip to the vertical black bar target mark located at the lower center portion of the windshield wile securing the nut. Tighten 35 N.m (26 lb ft) |
| 3 | Windshield Washer Arm Hose TIP: Disconnect the washer hose at the air inlet panel. |
| 4 | Windshield Washer Arm Assembly TIP: Use the J-39637 Wiper Arm Remover Tool. Special Tools J-39637 Wiper Arm Remover Tool |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.