Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Testing
Select both channels by switching the channel selector located on the side of the headphones and verify the volume is turned up. Also verify that the headphones are not in mute mode. Press the Sound Around ON/OFF button on the remote to change audio muting status.
- Ignition OFF, disconnect the appropriate seat headrest X2 connector at the monitor.
- Ignition ON, DVD playing, test for 15-40 mV A/C between the terminals on the monitor listed below and ground.
- Right Audio Signal - terminal 3
- Left Audio Signal - terminal 4
- If the not within the specified range, replace the appropriate DVD display.
- Ignition OFF, reconnect the harness connector at the monitor.
- Disconnect the appropriate seat headrest X2 connector at the DVD control module.
- Ignition ON, DVD playing, test for 15-40 mV A/C between the terminals on the monitor listed below and ground.
- Right Audio Signal - terminal 3
- Left Audio Signal - terminal 4
- If the not within the specified range, replace the wiring harness.
- If all circuits test normal, replace the DVD control module.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.